Search results

Try this thread: https://forums.servethehome.com/index.php?threads/brocade-inter-vlan-routing-on-some-but-not-all-help.43731/

Running for about a week now and temperature's fairly static with the asic fan mounted flat with twisties. Management/PSU/Ambient temperatures.

I don't have an after picture, but I connected it here:

People have used rubber bands to mount it as well as twisties/zipties to the PoE board screw/PoE power connector. There was a picture in here somewhere but I can't easily find it. I used twisties.

Different reasons but I also moved from Aruba S2500 to ICX7250 just last night. After the fan mod, it's the same noise level (subjectively the brocade might be quieter in steady state, and objectively it is quieter at bootup). Mine was basically because my port needs grew more than a single 24P...

I just twistied the fan in two places - the poe board power cable and a poe board mounting screw. Happy to report that with my switch (ICX7250-48P) in operation the temperature has stabilized at 69C mgmt, 33.5C air outlet. I'm using 4x 10G nics, 20x 1G nics, of which 5 are using poe totalling 17W

Thanks! I was eyeing both of those since a lot of people used mechatronics in this thread and my main fans got replaced with delta, but ultimately I went with a MF60101V2-1000U-A99 since it was a decent amount cheaper. Happy to report that the management plane temperature went from 85.6C no...

Thank you! I see that they're not stocked at digikey anymore for some reason (unless I buy 200), but there are alternative ones I can try.

Is that the black heatsink on the left of the board? I noticed it was really hot. Thank you for looking up the part!

Fan mod question! I have an ICX7250-48P and I found some delta fans on a walmart seller (5 for $20) which were the right model I was looking for, but of a weird revision that doesn't seem to exist on their site. Anyways, long story short, I swapped three fans in, and the noise level is great...

Hey folks, I tried searching this thread but didn't find the exact thing I'm running into. I'm following the doc on updating first in the bootloader but the tftp is failing partway through when updating primary. Any tips? Maybe a faulty NIC? The update_uboot worked properly but that could have...