I got the kit at home now and are trying to connect to the management port. From what I understand it is a regular RJ45 and IP protocol to be used however I cant connect to it. I get no live connection indicator in the switch nor can I ping it on any IP address. Can the management port be...
Anyone got a hold on the firmware that recognize all HD brands and tools for flashing the gen1?
I am about to jump on one on ebay and it would be nice to know that I got a way to use non-WD/HGST drives if need be. I am at this point in time only running shucked WD Elements so I guess they will...
Heads up!
Two weeks after deal was set with a price for the JBOD and with wait for it to be sent seller made excuses for jumping out of the deal.
Reason: I was offered other items during my wait for it to be sent. One I accepted suggested price for but the next I apparently tried to bargain...
Thanks for the input! ..I certainly are'nt well versed in electrical matters so I value any input in the matter. Please do tell if you find any suitable alternative to 'my' relays here. I do like the board however as it holds some good logic (Arduino compatable) and wifi module/web page with...
Yes, they are all electrically connected but I have two relays on each backplane of 16 drives each. So thats 8 drives on each relay. I think I'll be ok.
At any rate I have managed to jack into the serial port of the backplanes and got some healthy readings and feedback from a few ideas. At last...
Really?
Could you please point me to a source for that information?
..from what I have read the wattage is the culprit and you can recalculate the current and amperage based on the max wattage value.
https://relaypros.com/choosing_proper_amperage.htm
Well, from how I understand it's all about the power load (wattage) you put through them.
The relays are rated for 30A @ 30VDC (900W) which if recalculated to 12VDC gives me 75A (900W).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.