Search results

I have the SG350x-48-K9-V06 My SG350X 48 sounds like it is about to take off. I only use it for a home lab and there is no heavy usage, so I could not understand why the fan was so noisy. Because of where it is located, the rest of the family were not happy with the sound. It has been switched...

After installing the required software, my PWM fan was working initially. However, following a recent Proxmox update, the fan and sensors stopped appearing in lm-sensors and ceased functioning. Reinstalling the software resolved the issue. Do I need to reinstall this after every Proxmox update...

I am in the UK and attempted to purchase the GST90A12-P1M adapter for the n305 from a electronics supplier. However, the vendor declined the sale citing CE/UKCA compliance concerns. This appears to be a misunderstanding. While older datasheets (e.g., GST90A-SPEC 2016-03-16) may not explicitly...

@Apachez @splifingate - thanks for the advice, added a cheapy heatsink to the nvme and dropped temp significantly, only cost around £4 from amazon.

I've got one laying around somewhere, how much temp difference was there pre/post heat sink?

Thanks, I was getting ready to do an amazon return and looking for replacement. For reference I am also CW-AL-4L-V2.0 N305, the drive in question is a Patriot P300 512gb. The second drive is 2tb SN770 whose temperature are more sensible <50C.

Just got round to do further testing: Temperatures looks to be fine, except for sensor 1 which is showing around 70C, it's a brand new drive so wondering if it's defective! nvme-pci-0100 Adapter: PCI adapter Composite: +50.9°C (low = -40.1°C, high = +83.8°C) (crit =...

The unit idles around 35C, I'll probably redo the thermal paste. Do you use a fan on yours?

I finally had a chance to test the system, and while it seems to be functioning, I encountered an initial issue. During the first boot, I heard the system beep, but there was no display on the monitor. I was using a DisplayPort connection (actually, it was a DVI cable with a DVI-to-DP adapter)...

Here's what mine looks like XinSPower :

Got in, it’s very late so won’t get much done, had a look inside trying to figure out what’s what. I’m not too sure about the thermal paste it doesn’t look likes it’s spread properly though will check out temps before redoing it. Was hoping there’d be some instructions but besides warranty...

Arrived today and has the same h board. unfortunately I need to take the kids out now so unable to do any kind of build but will post some pictures later.

I got it via Aliexpress. I’ve asked but their response is I’m not sure what they mean by that.

Thanks. I don’t think mine comes with a h-board, it’s due to arrive on Saturday (ordered Black Friday) was out of stock but i got it dirt cheap which is why I’ve held out for so long. So far I’ve sourced Corsair vengeance 48gb and 2tb wd black. You wouldn’t happen to know a link where i could...

Not sure which model i have but it's this one N305 version. I was planning to use a SATA SSD and an NVMe drive, but I noticed you're using two NVMe drives. Do I need any extra hardware or an expansion card to install an NVMe drive in the M.2 slot intended for the Wi-Fi card?

Hi, I'm new here and apologies for not searching in advance but there is so much to read through wondering if any can help me out. I've purchased the N305 unit which is Variation C from the picture on the first page. What i am trying to understand is whether i can install an NVME and Sata 3...