Search results

The KiCad design files and Gerbers have been uploaded and are available for anyone to use. The dimensions are 17.4 x 7.9 mm.

I bought a Supermicro ATX power supply, model PWS-1K25P-PQ, that comes with SMBus support. ASRock's IPMI reads the standard PSU address of 0x58, but the Supermicro PSU's address is 0x3C. I built a custom address translation board myself and successfully got the motherboard to recognize the PSU...

Hi RolloZ170, Thank you for the suggestion, I figured it out. I just need to set a custom temperature in either open-loop or closed-loop control, and then change the corresponding fan's control method to the custom mode instead of the default mode I had selected previously. :D

Hi MSameer, I found a problem. I tweaked the temperature vs. fan speed curve in the BMC, but it's not working. The AI check says the motherboard has hardcoded Curve 0, which we can't see. For this curve, the lowest temperature of 60°C maps to a 35% fan speed. Can you check if it's the same on...

I successfully flashed the MBC and BIOS firmware. I used the Instant Flash tool in the BIOS interface to flash the BIOS firmware. I once tried flashing the BIOS in the BMC interface, but it stayed stuck at the 100% uploading screen. I actually flashed the BMC from the PVE terminal; you need to...

:D After flashing the BMC firmware and BIOS, do you have to restore/reprogram the NIC's MAC address?

Hello msameer, is the 5.07 firmware motherboard‑specific? I mean, does it vary across different motherboards? I've been considering whether to upgrade the BMC and BIOS, as I'm worried about losing the MAC addresses of the network cards.