Search results

I encountered the same problem. Have you solved it?

Thank you, ThinkSystem Mellanox ConnectX-6 HDR100/100GbE QSFP56 2-port VPI Adapter has been flashed properly.

I also encountered a similar problem, may I ask if you have resolved it here?

MCP2221a_iccmax_FF.exe -PXE1610C 5A 5C 谢谢您

MAY I ASK THE ASUS WS C621E SAGE THIS MOTHERBOARD CHIP SHOULD BE 1610C, THE LOCATION OF THE JUMPER I PROBABLY FOUND HERE, I DON'T KNOW WHAT CODE TO USE TO BRUSH,Corrected the error, the 5.3V in the figure below should be 5.3Ω

Thanks, it was successful to brush with this code MCP2221a_iccmax_FF.exe -PXE1610C 74 MCP2221a_iccmax_FF.exe -PXE1610C 76

I measured these 2 pins to the chip resistance is around 51Ω

I re-downloaded your program and now the output is as follows: I:\bios\HR650X\MCP2221a_VRM_mod(10052024)>MCP2221a_iccmax_FF.exe -scan 20 70 MCP2221a VRM mod utility (build 10.05.2024). The MCP2221a device is connected. scanning at addr: 20 scanning at addr: 21 scanning at addr: 22 scanning at...

Help me see the Lenovo HR650X I can't find the address

Thanks for this done

Pls after I connect to the DB_VR_P0 with USB005, is it possible to adjust this place with PowIRCenter software

RolloZ170 Help me see if this is it，I took pictures of all the chips

I feel that the chip and jumper are in these 2 pictures, and I don't know if there is a program that can be brushed

Help me see which one is the power chip

okey。 Thank you

I used this brush under EFI before

The CPU I tested was EPYC 7542