Search results

did you leave it on for a while? when i updated bios it took nearly 5 minutes for it to boot to show the bios screen. try leaving it on for some time

with the banning of many other brands of routers in the usa lot of people are turning to custom route for long term support and futureproofing. so they are all selling out.

Iv got some time off work next week so will take a look at updating the i226v firmware on my cwwk box. Is it best done through windows?

for proxmox and other production based stuff i find my inter m720q is by far the best option. the intel nics and platform are better supported.

both the athlon 300ge and ryzen 3400ge are 35w. gave it 15 mins and no boot. bad cpu sent it back for refund. already on latest bios too

so got a 3400ge cpu to replace the athlon 300 in my m75q-1. issue is with the 3400 in i get no display and the fan just runs at full speed. put the athlon 300ge back in and its working fine. dud cpu or do i need to reset bios or something and try again?

got a m75q gen1 coming. will try some mods on it and see if it can run modern cpu like 5700ge etc

since this is am4, any possibility of a custom bios that allows newer cpu's like the 5700ge to work?

running the A1000 in a m720q with 8500T and 32gb ram. its an excellent gaming rig.

yes got to install the plugin

has been since last year

found this setting in tunables section in gui of opnsense its already set to 90

sata port wont pick up a sas drive

Check opnsense forums. Iv posted in there and they have the commands to run to bring up the live monitor that shows what's writing to disk

i believe for me its caused by crowdsec and zfs itself. hostwatch was causing some writes too but i turned it off. iv got logging set to ram drive but i guess it still puts some stuff to flash.

my opnsense sits around 1gb a day on writes. so even at 500gb per year a drive with 60tbw can get what 30 years out of it?

Managed to find out what was causing the high disk writes. Host watch and crowdsec. Host watch was the main one which iv delt with now so will see how things go

Same here managed to recover a 64gb nvme since flash is now expensive. Also is there a way in opnsense to see what is causing the writes to disk?

Yikes I didn't think they would be that low on endurance.

Temp sensor deffo works just checked now smartctl 7.5 2025-04-30 r5714 [FreeBSD 14.3-RELEASE-p8 amd64] (local build) Copyright (C) 2002-25, Bruce Allen, Christian Franke, www.smartmontools.org === START OF SMART DATA SECTION === SMART/Health Information (NVMe Log 0x02, NSID 0xffffffff)...