Search results

I'm not aware there is another way than direct programming ob BIOS chip, but surely if someone knows how, I would be very thankful for that information.

Unfortunately no

It's vendor locked for Dell. I didn't notices when I bought. I bought it for $71,70 and I'd like at least $50

I meant https://www.serverparts.pl/

I bought mine from same Polish distributor. Lot of troubles with them. Never again :D

Spent whole night with it, but finally was able to flash latest Supermicro BIOS without desoldering. I don't know if there is problem with Linux or programmer SW, but only way I made it work was on WIndows and with Neo Programmer.

Well, looks like even with CH341A I can't bypass write protection. sudo ./flashrom --progress --programmer ch341a_spi -w BIOS_X11DPU-091C_20240305_4.3_STD.bin flashrom v1.5.1 on Linux 6.11.0-25-generic (x86_64) flashrom is free software, get the source code at https://flashrom.org Found...

@RolloZ170 Don't you know which TDP does H12SSL support? Web says only "Up to 64 Cores", no TDP. Nothing in manual either.

I was planning upgrade to Milan anyway. Looks like it will go earlier :-)

Looks like H12SSL does NOT work with Naples. At least with Epyc 7551P definitelly NOT. Tested today myself. Maybe RAM could be the issue, but I highly doubt it. I used Micron 2Rx4 PC4-21300 36ASF4G72PZ-2G6D1

Looks like H12SSL does NOT work with Naples. At least with Epyc 7551P definitelly NOT. Tested today myself. Maybe RAM could be the issue, but I highly doubt it. I used Micron 2Rx4 PC4-21300 36ASF4G72PZ-2G6D1

I received this with my 12-board package, so I was hoping someone from you guys will know :-) Ah, makes sense :-) Shame M.2 slots are not working :D

Does anybody know what is this good for?

Just bought few SYS-6019U-TN4R4T with X11DPU. Same problem as @XeonSam have. Tried everything except CH341A programmer. I was tempted to try it too, but then I found out I have 5V version, not 3.3V I need and with my eyes I'm unable to modify it. Ordered new v7 with voltage switch, will see...

I tried ARCTIC Freezer 4U-M Ampere, because it has proper airflow (to the back of the case, not up), but it won't fit, even though it should be compatible with SP3 specifically. The metal mounting parts go too far from socket and there are on-board components under them :( It's shame, I really...

It is not true. Click download icon in upper right corner, than click Or continue with download only on the bottom of dialog window.

Didn’t had time for this lately, but I’m not finished yet. This is fromChatGPT Deep Research EPS Connector Pinout (Source Side) for Brocade ICX6450 The following table outlines the 20-pin EPS connector layout on the power supply side (EPS1500 / EPS4000) used for powering Brocade ICX6450...

Sice you don’t need any more, can I ask where you get those PSU’s?

@luckylinux Regarding IO shield, you will be printing it on 3D printer for those cases you bought?

Looks like I hawe too small balls to try such an offer :D What about postage for 30 pieces, isn’t it insane?