Search results

  1. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    DL360Gen10 mod was success, 2x 8259CL run perfectly nice in stress --cpu 96, Geekbench etc! Much love, also Optane PMEM DIMMs work too!
  2. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Haha, yes I just noticed that... Mod success! Next week I get new cpus to try =)
  3. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    scan seem to work? command pxe1610c 62 64 doesn't?
  4. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Little confused as it nowhere say J266 pin, but I believe I put correct place.. Or is issue I did not use the cable that come from programmer instead I put to the pins on the programmer?
  5. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Machine is DL360 Gen10 Board is powered on and has two supported CPU. I have connected as your image to my Adafruit MCP2221A GND SDA & SCL pins
  6. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Hello. I have such. Any info?
  7. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Ah great, so I can program it already with my supported ones! Nice then I will just need to replace the new CPUs when they arrive and enjoy :)
  8. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Hey actually quick question; Can I do the programming with supported CPUs or does it need to be done with the unsupported ones.. Sorry if it's obvious, but can't hurt to ask :)
  9. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Thank you for the info and for the nice forum post. Ain't this the best practice board :p
  10. J

    VRM modify ICC_MAX to run high TDC OEM cpu

    Getting ready to do my mod for my DL360 Gen10, still waiting for the CPUs (2x 8259CL). Wanted to ask, does this look like it'll work? I believe these are the correct pins... I hope :)
Top Bottom