Search results

Here is my output from lspci. I have all 6 sata ports used with spinning disk and the 10gbe NIC in the PCI slot. When I get time tomorrow I will put in a nvme drive in the first slot. I took it out when attempting to get a 10gbe nic working. FYI Crystal disk in Windows reported 797MB/s read and...

I spent about 4 hours trying different settings and never could find a combination. The fact that the 2 cards i mentioned never powered up or showed up in linux using lspci tells me it has something to do with power. I know my way around Linux (been using it since 1997) but honestly I am lacking...

Just wanted to report I finally found a 10gbe card that works. I just remembered I had an old 10G qnap card sitting around (need to sell my old qnap since replacing it with truenas). Here is the card info using lspci: 01:00.0 Ethernet controller: Aquantia Corp. AQC107 NBase-T/IEEE 802.3bz...

Tried the card in another machine and it works fine. I also tried a Marvell AQtion AQC107 10gbe card and no go. I know the slot works withPCIe 3.0 X1 cards because my 2.5gbe nics work fine. I wonder if there is something in the bios I have to set to make this work. Both cards I tried do not show...

I purchased the CWWK i3-N305 six-bay NAS monster board/4x 2.5G/6x SATA3.0/2x M.2 back in early december. It is a little janky at times when booting but it has been really stable for me. I am running it with 32g of ram and 6 spinning drives (stripe/mirror multiple vdev) in Truenas. I purchased...

I just got the SL-SWTGW218AS. I am struggling trying to figure out how to setup VLAN's on this. Specifically the PVID section Here's my setup: OpenSense Port 1 (WAN) ---> connected to FIOS OpenSense Port 2 (VLAN) ---> connected to Port 2 on Switch OpenSense Port 3 (USER) ---> connected to...