Separate names with a comma.
They are r730xd.
They are about 4years old but have run only for about 2.5 3 years.
I bought them myself from Dell.
One in 2017 and one in 2018.
Well I do not remember the specs as it have been 2 years since I saw them. But overall , a dual xenon 5400 or 5600 series 6 cores in each node....
Hi, my question is simple yet complicated in the same time.
I may have an opportunity to aquire a 2 Dell r730xd servers fully loaded.
Zamana.. just an FYI but proxmox supports zfs now and well.
Yes the GUI is limited but com and line is not too bad for most use.
I am currently...
Well, I had a good experience about 9 or 10 years ago.
I found a 24U cabinet listing and bid 24$ for it. Local pickup.
Did it for fun mostly. Not...
Thanks. Just got one in mint ,supposedly, condition. Will see when it gets here.
The issue they jumps out for me is that your existing hardware is very diversed. When you run a HA cluster all nodes need to be as close in config...
Thanks. I figured I will look at samsung first anyway. Just bid on one at 415 right now. Will see.
If I can get a samsung note 9 or huawey p30 pro for around 450$ for us market.
What is the better choice.
As it is they both fit my basic criteria...
Execept for ESXi or maybe Proxmox I wouldn't use any others on usb disk.
ESXi is thr best contestant as it is run mostly in RAM once booted.
What is the problem here?
It looks like a standard pc power cables.
They will work for anything.
Yes usually servers come with a thicker cables....
Just want to update.
Found an ubiquity AP on eBay.
It is an older model so needs the controller to configure and run. But works. Spend almost a...
Not sure what is that case but try Rackmount Mart - 5U Rackmount Chassis
Yes the wndr is access point only. No routing no dhcp. The reason I wanted a router capable being an access point is that I only have 1 network...
Here is my issue.
I am in USA.
At home, I run a pfsence setup from the ISP to switch. For wifi I use netgera wndr3400 in AP mode....
I would say, first of all forget sbs2011.
It is not supported anymore.
If you want hyper-v. Winaserver 2012 and up is the only supported OS.
A little update here
I have tried to setup aria2 in Proxmox based lxc container.
For the love of all holly could not make it work. Followed 6...
You do not need to reconfigure them.
I assume that you had a separate os drive and 2 data drives ib zfs raid1.
If that is correct than just...
Is it still available? I just want to know the cost of getting it. If it is within my budget would like to get a second machine for my setup.