Separate names with a comma.
I have tree switches. Two of them are working just fine.
The last one did not boot up after a power failure on the main supply of my house.
Not sure if this is the right place to aske...but..
I bought a Quanta QSSC-2ML server from natex.
It works just greate., but i cant figure...
Shipped direct. Have never used jetcarrier before.. is that cheaper?
I just ordered one quanta server. Looking forward to try it out!
Takes a long time to ship it to norway...
Does anyone have experience with the Quanta QSSC-2ML server ?
It look realy ok. With two 2670 and 128GB ram and 10Gbit SFP+.
I'm getting a lot of log entries.. All i have done on the switch is set all ports in admin mode. To get them active.
And I get this log message on...
I was now able to mount the VM disk in esxi. When I'm copying the files over to my mechine, do I only need the vmdk file ?
I did install esxi on a usb stick. I can now boot it.
Under "storage -> datastore" I only see my raid5 (4x2TB)
If I hit "Devices" I can see my VM...
I'm running an esxi 6 host on my Dell poweredge 2950 G2 with perc5i raid controller. Running 4 2TB WD disks in raid5 (storage) and one singel disk...
I have a new "problem".
If I run say like a CS (counter-strike) server, connected to the switch. The clients dont get it up on "local games". You...
Ahh.. firmware :P
I se a LOT of log messages under Log -> Buffered log:
FEB 18 18:28:23 10.0.200.77-1 UNKN: rlim_api.c(1112) 55545 %% invalid tunnel...
33*C is the temp.
I have my computer connected to 1G true 10G to router. Router is connected with 1G to ISP.
If i connect with an older zyxel...
10 Gig uplink to routert is 10 Gbps full duplex. and 1gb i 1gb full duplex.
Physical Mode is AUTO
I'm running all ports on same vlan.. (1) Have only activated the ports. But I have slow throughput. 400Mbit/s on a 1Gbit link.
I've tested with...
Is there a way to set dhcp relay on each vlan or dhcp server on the switch ?
4/1 - 4/3 is interfaces that is created when i set ip on each vlan.
I'm able to ping bouth .1 ip's.
To be honest I dont know :p
I was trying some cisco commands.., and suddenly I could ping the other VLAN.
Here is my running config:
I have been able to connect between vlan. But i''ve not been able to make a gw for all vlans. Is there an easy way to do this ?