Separate names with a comma.
Newbie to Infiniband.
Had several MHGH28-XTC and CX4 cables from a deal , would like to try out Infiniband/VSAN in my home lab.
I have the same issue (no useable memory)with this motherboard and now it even refused to post anymore after tried some different memory
Tried the OI-hipster-minimal-20170502 with Napp-it.
However, upon importing a zpool, it complaint about unable to do NFS share.
Just had a new installation of Omnios 15022.
Followed the steps on the OS setup pdf to upgrade it from 15022 to CE edition 15022i,...
I would say, avoid Intel motherboards, they tend to have more problems, support less CPUs (not supporting OEM, ES, QS cpus).
what's the sideband for?
Good price. But I'll hold and moving to v3 system now.
Yes you are rigjt. It could be the forst generation card, with 2.2TB problem. While the 9201 is 2nd generation 6Gb
I found some cheap HP D2700 chassis for $250 around locally
how would you connect the HBA to those SAS drivers sit in the bays?
Has any one had experience with this card?
HP ATTO H30F 16-Port 511799-001 ExpressSAS Internal SAS SATA II Control Card
HP ATTO H30F...
Is there any reason to favor this one instead of the cheaper famous 36 Port 6G 'HP SAS Expander'?
I wonder this should compatible with the 'HP SAS Expander' ?
Through in one of this card, one expander and one Norco 4220/4224, I'm should be good...
Would the Intel
RMS25CB080 able to be flashed into it mode?
Just been lazy don't want to change the cable and attach another hba
this is for optimo performance
You can have just one module installed, it's just slow the system down due to remote access the ram
No, I don't have the RMM module.
The board does have BMC, I can access the bmc lan http login page, however I haven't configured a password for...
nothing attached, only two processors, one ram module, several fans at the moment, that's all.
kind of minimum system.
Used to have a raid controller plug in, but now it has been removed
Thanks. Yep it does have emergency recovery, hope it will work, will try sometime later.
It shows the first booting up screen but can not pass it....
Yep no drive or add on device or pcie cards connected;
have tried taken the battery off the board while clear the comos.
ii'm afraid the problem...