Separate names with a comma.
I'd like to see how high you can go with an EPYC 7002. Anyone plans to get one and test how high it can go?
Moved the SAN to our production cluster - some new results available in the wiki
Which gives you 57% render advantage while having 100% more raw power - IMHO not impressive ;-)
But nice toy if you do more then one job parallel.
As EffrafaxOfWug said, it does not scale beyond 12 CPUs, so this is benchmarking 12 Broadwell-E Cores vs 12 Skylake cores - meanwhile 32 Broadwell...
So with this knowledge this platinum actualy doesnt look too good compared to his predecessor.
Are you sure your software can handle 88 threads? You may run the benchmark again with only one cpu active? - also this would give a good...
In your UEFI you should have an option to select primary video card - on my Gigabyte X370 I can only set that option properly if I have a second...
Single runs with qd1, qd10, qd256 and a parallel run oft two VMs with qd256.
If your data is important you MUST use sync=always, else you loose...
use a VM as gateway and passthrough the card - not perfect solution but should give you enough speed anyway
Reading the changes and came to the qemu point, then I'm reading qemu4 changes and see this:
Q35: advertised PCIe root port speeds will now...
I think there exists a dual ported 100GB DC P4800X
If I compare these results with the ones here (with optanes) on page 51 http://napp-it.org/doc/downloads/optane_slog_pool_performane.pdf I'm quite...
There are 10 (dual-ported) u.2 nvmes, which can be accessed from both nodes. I have played around with the raid setup and actually got better...
worklog and some resluts @the end
here my worklog and some bench results @the end
I know it's an old thread but the answer is yes you can.
I'm doing so with ocf:heartbeat:IPaddr2 and RoCEv1 with Globalpause.
I would like to use scst (actually I would like to use LIO...), but havent found any good (working with ubuntu ootb w/o doing debugging all time...
Mellanox suggests in using MTU size of 4200 for iser, as I'm doing.
This setup is on ubuntu 18.04, tgt and scst is working fine, but esxi is...
I usualy use nmon for that.
nmon -> M -> M -> M
Downgraded OFED from 4.5 to 4.3 and scst is working. Trying LIO tomorrow.