Separate names with a comma.
Received my memory, perfect pacacking and memtest passes smoothly.
Just got myself 24 x8GB for my homelab :D More VMS :)
Got the 4 SSDs, all perfect. All tested, about to put them into use.
My bad, I forgot to check the date of the original message..
I would be interest on one depending on the price.
Perfect, I thought they were selling just the low profile replacement.
Did you purchase an extra bracket in low or high profile? If it is high profile where have you find it?
If you check properly it gets the power from the 12V, however, on the molex side its only 5v. As is it is connected and with the ground cables.
You can use the 2 OPT_12V close by the PCIE_RISER, you just need a 4 Pin Molex To P4/64 Bit ATX 12v
Anything like this will get you a...
You can flash the FRU and update the information, but there is no benefit. It´s just for the information that appears on the BMCconsole.
My plan is to try to get the systems fans to be at the lowest speed ,before triggering the low critical thresold around 2100 and...
***I'm not responsible of any damage done to your system, proceed at your own risk****
***Remember to check on the temperatures, it works for me...
The file i'm editing is S2600GZ.sdr , it´s part of the bios flashing, step 4.. You only need to flash the SDR not the FRU.
[ATTACH] I have managed to get the FANS down, but I think I can still tinker a bit more with the settings. I need to figure all the sensors and...
Thanks, I´ll try to update the FRU and see If I can get the FANs to slow down. Then I´ll try with the SDR to change to global stepcurve to slow...
Hello, I purchased one of this servers and while trying to update the SDR file to custom settings to lower the RPM fans, I messed up and I lost...