Search results

I experienced a similar issue when I enabled my CIMC port to share GE0/0. Once I reverted CIMC to use its dedicated port and unplugged the server for a bit it fixed the situation.

Anyone tried replacing the sata ssd with a bigger one? My ENCS doesn't see it when I replaced with a 480GB Micron sata m2 one

enp5s0 is a X552 10gb nic integrated in the xeon processor afaik, but it is not exposed anywhere externally.

Update on getting the switch online after boot. Guide to setup a bootstrapping VM: Switch bootstrap VM | Notion Python package for injecting configuration: GitHub - yeyus/marvell-11abbe00: marvell switch configuration

[79138.032478] ata1: SATA link up 3.0 Gbps (SStatus 123 SControl 300) [79138.032711] ata1.00: ATA-7: SSDSA2SH032G1SB INTEL, 845C8862, max UDMA/133 [79138.032716] ata1.00: 62500000 sectors, multi 1: LBA48 NCQ (depth 31) [79138.032990] ata1.00: configured for UDMA/133 [79138.033154] scsi 0:0:0:0...

Correct! I installed proxmox v8.1 without almost changing anything just mapped the CD drive to a proxmox ISO and followed the install prompts. I haven't tested any of the SATA ports yet but I should have some low capacity 2.5 SSDs laying around. I'm right now mostly focusing on getting the...

Another quick update about auto media sensing this time. I just installed proxmox in one of the units I have, install was uneventful using MGMT interface (enp15s0), then I dived into the dual personality ports (GE0-0/enp2s0f0 and GE0-1/enp2s0f1) Upon boot I checked the igb module output and...

Some reverse engineering info about the switch: It seems the switch ASIC is a Marvell Prestera (98DX3***), it has its own ARM CPU that is PCIe mapped, the linux driver as @turbo said some time ago is mv_pciboot will probe and map the Switch ASIC register into its BAR and expose a block device...

Were you able to get dropped into a shell through 22222? cisco documentation states it is an SCP only port

Is this the weird Marvell "be00" pcie device?

I just got a unit and I will start looking into the VLAN in-band management, if anyone has software for this unit would be extremely appreciated

Do not power this card with a 8pin to 6pin gpu cable!. The polarity is reversed. I just checked and I'm getting 12v on the tab side

Got video capture working: Video source is an Amazon Fire Stick. Steps: 1. Grab Omnitek drivers (PCI Device 1AA3:*) from original windows distro. You will need the inf and sys files, in my image they were in the Windows Driver Store. dism /Online /get-drivers /format:table 2. Grab Omnitek...

@scabskunk I'll look into it. For now I've been playing with HDMI capture It's still complaining about some filter library but it seems promising. It seems that the FPGA board registers as a custom media driver on windows using a driver by an intel acquired company called Omnitek. It looks...

Seems like EWF is enabled, so all changes you make are only changed in an ramdisk overlay. If you want to persist any changes you make run EWFMGR.exe C: -COMMIT I've been playing with the original disk image in a kvm VM and I'm trying to bring it out of kiosk mode (most of them seem to be Group...