Search results

I was curious how the smart redundancy option works for Unleashed. I was looking to enable this option as I snagged two R730s which I've flashed. Unleashed only mentions what happens when there is a failure wit the master and doesn't really address the sequence for recovery. "Enable Smart...

It would certainly be nice if that was a feature. On another note, I was curious if there was a trick to getting the application reporting to work. I've enabled the Application Visibility on several of the SSIDs that I've set up, but I have yet to be able to get any information displayed under...

Would be cool if anyone was able to get the Zigbee controller working. It seems like it would complement those who are running a Zigbee network in their home or office, for sure!

Meant to thank you for the reply. I was able to get the R730 flashed and am amazed at how much more coverage I get with one AP versus my three Uniquity which I have installed. I now have two switches and two Ruckus AP which has taken my setup to a whole new level.

So that I understand this correctly, if you side load the AP with the R850 software, it will completely shut off all wireless on this device? It only then acts as an Unleashed Master and won’t be able to host any clients via WiFi? If that’s the case, then why not just go with an R710 and use...

I just made one like this with the Cisco FTDI and it worked like a charm!

That's the cable that I had purchased and it does NOT seem to be working. After having a panic attack yesterday thinking that I just turned my new switch into e-waste, I am to understand that what you linked is a traditional USB cable and does not provide FTDI required to access the port. See...

You certainly made my morning! Thank you for the info and for not flaming me! This thread is so long a lot of the previously linked items would lead to dead ends. It's very reassuring to hear from the Godfather on the matter directly. My 15 minutes of digging last night didn't come up with that...

Okay, finally got the switch in. I ended up getting an ICX7250. So far I'm off to a rough start as I can't seem to get Windows to detect, and/or get the TFTP up and running. This is the cable that I purchased; can anyone confirm if this is the correct cable and should work for connecting to...

Ahh, thanks for the clarification on the USB-C issue. I guess I won’t have to worry about that with my 6610 since after looking at the manual I see that the serial console ports are rj45 and on the back with the 48 port switch. For some reason I thought that the serial console cable plugged...

I just picked up an ICX6610 which should be arriving next week. Reading through the threads I saw these two serial cables mentioned in this thread that people have used. Would someone be able to confirm if both of these will work, or if one is preferred over the other? I know that they are...

Yeah, this one is not coming back. The magic smoke has been let out. :( It lived such a short life. Seems like these are getting more popular and therefore more expensive on eBay. Maybe I'll get lucky and score another one in the future.

Sigh....Thanks for pointing out the obvious and for not flaming me. :) I should have paid more attention on the first page and not assume that it was the same for as my M720Q! That does make me feel more confident on getting this up and running if I can swap the board out again.

Has anyone had a bad riser card for their M90Q? I purchased this 01AJ940 from eBay which seems to be the only thing which has fried two motherboards. I installed the riser and a PCIe adapter card for the first go-around a few months back. As soon as I plugged the unit in I saw a puff of smoke...

Thanks for the quick response. Seems like it's a good option for my use case. I heard about this deal on the self-hosted podcast and wanted to take advantage of it.

By any chance, would the 7050 be sufficient to stream 2-3 instances of Jellyfin?