I have tree switches. Two of them are working just fine.
The last one did not boot up after a power failure on the main supply of my house.
It stopped on "loading kernel from nand". I then found a guide: New RB951G-2HnD bricked? [Solved with Netinstall] - MikroTik to use netinstall to install...
Hi
Not sure if this is the right place to aske...but..
I bought a Quanta QSSC-2ML server from natex.
It works just greate., but i cant figure out how to get power to the 4 extra hdd's that is not connected to the backplane?
I cant find any connections to take out power from.
As you can see...
I'm getting a lot of log entries.. All i have done on the switch is set all ports in admin mode. To get them active.
And I get this log message on all active ports:
I did install esxi on a usb stick. I can now boot it.
Under "storage -> datastore" I only see my raid5 (4x2TB)
If I hit "Devices" I can see my VM disk. But how can I access my files on it ?
I'm running an esxi 6 host on my Dell poweredge 2950 G2 with perc5i raid controller. Running 4 2TB WD disks in raid5 (storage) and one singel disk as system disk and VM.
It's been running for several years with esxi 4-5-6 with no problems.
No suddenly I'm not able to boot up the system.
The...
I have a new "problem".
If I run say like a CS (counter-strike) server, connected to the switch. The clients dont get it up on "local games". You have to connect with IP address or domain. Is there a way to make this work ? Both server and client runs on same vlan.
I se a LOT of log messages under Log -> Buffered log:
FEB 18 18:28:23 10.0.200.77-1 UNKN[147406336]: rlim_api.c(1112) 55545 %% invalid tunnel intfid (32)
What does this mean ?
33*C is the temp.
I have my computer connected to 1G true 10G to router. Router is connected with 1G to ISP.
If i connect with an older zyxel clean 1G switch. I get better speed.
I'm running all ports on same vlan.. (1) Have only activated the ports. But I have slow throughput. 400Mbit/s on a 1Gbit link.
I've tested with another switch with same config. And here I have 700Mbit/s.
To be honest I dont know :p
I was trying some cisco commands.., and suddenly I could ping the other VLAN.
Here is my running config:
(BX-Core) #show running-config
!Current Configuration:
!
!System Description "FASTPATH Routing"
!System Software Version "5.13.12.14"
!System Up Time "5...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.