Thanks for the additional information! It turns out I just hadn't properly connected the 12v line.
I didn't order directly from CWWK so ended up making my own adapter.
Does anybody know the pinout for this fan header on this CWWK unit with an N305 and 6 eth ports?
The one combination I tried didn't work and I don't have the tools to quickly check different pinouts. :(
I tried searching this thread for a little bit but couldn't find the answer.
EDIT: nvm...
To give an update on this, turns out it wasn't the motherboard at all! The 2 fans that were attached to the FAN4 header seem to draw an insane amount of power while only spinning at 1400 RPM. I only found out about this when I tried a stand alone fan controller and got the exact same issue of...
I've also tried zone 0, nothing :(
Have also cold booted a few times.
I'm thinking of just getting a fan controller of some kind and bypassing the motherboard alltogether. But I do worry what else isn't working properly and that it's not just the BMC chip... o_O
Edit: something I forgot to...
Yep on both. I've even resorted to trying to set the lower threshold of FAN4 to a value higher than what it's reporting just so force it into panic mode but that didn't work either. If that had worked then at least I'd have spinning fans..
Getting some major headaches with this X11SSi-LN4F. I've had no issues with a different X13 board but this X11 board will only spin the fans from the FAN4 header. If I unplug that while it's on it'll spin up everything else in a panic but besides that there is no actual method to spin up the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.