Search results

I don't know who needs to hear this but it was a pleasant surprise that my new (to me) Brocade 6450 can power 2 unifi pro APs, a voip desk phone, and one of those grandstream cordless base stations while running fanless. Temps bumped 2C and stayed there for 24h now. My rack is in the basement...

Resolved: I have a ve on vlan1. Thanks to @kpfleming 's note, i tried to route-only the port and got a helpful error message: SSH@chonk(config-if-e1000-1/1/48)#no route-only Error - Cannot change Route-Only setting on physical port that is part of a VE Note - Route-Only is not active (config...

Thanks. I can create VEs and assign ips to them no problem. So I'm pretty sure i can get done what I need to get done.. It just bugs me that all of the documentation and other videos in that series suggest i should be able to assign an ip to a port and it doesnt work.

Thanks for the question. I appear to be running the Router firmware: SSH@chonk>show flash Stack unit 1: Compressed Pri Code size = 9871112, Version:08.0.30uT313 (ICX64R08030u.bin) Compressed Sec Code size = 8485640, Version:08.0.30eT311 (ICX64S08030e.bin) Compressed Boot-Monitor Image...

SSH@chonk(config)#int eth 1/1/48 SSH@chonk(config-if-e1000-1/1/48)#ip address 10.10.10.1 255.255.255.0 Invalid input -> address 10.10.10.1 255.255.255.0 Type ? for a list SSH@chonk(config-if-e1000-1/1/48)#

I recently purchased a 6450 and followed the guide. Everything seems to work and i'm running on v. 08.0.30uT313. For the life of me I cannot figure out how to assign an ip address to a given port: SSH@chonk(config)#int eth 1/1/48 SSH@chonk(config-if-e1000-1/1/48)#ip address...