Search results

7532. It will be for VMware workload. Any suggestions?

Thank you!

I start working on AMD EYPC Milan platform (Dell R7525) and noticed BIOS settings such as NUMA Nodes Per Socket and L3 cache as NUMA Domain. What's the recommendation and impact? Any other settings I should be aware of? Thanks Mark

I have a pair of arista 7050qx-32s behind 1120 and running into NAT access issues. I have over a dozen vlans between FW and switches. From 1120 I am able to ping 7050 and internal servers but remote access via NAT timed out. From the packet trace I can see traffic went all the way from FW to...

So did they ever find the super secret chip on the supermicro MB? No. Do they successfully launch the campaign against China since the article? Yes. Is China USSR? Do we want another cold war? Who is benefiting from all of these? In the cloud age, servers are commodity, who is willing to...

Both 2 & 3 works. Just be aware, unlike all flash, you can only do RAID 1 without deduplication and compression.

When I try to remove the unavail disk I have the following error: cannot detach 6421037529530817339: no valid replicas I only use the storage present iSCSI LUNs to VMware. So the error message point to the LUN itself.

Thanks @gea I could not delete any of the drive mentioned above. Have the following error: cannot detach c6t5000039628D97C26d0: no valid replicas Any other thing I could do?

Thanks @gea I added another clean drive use the replace drive function. As you can see, after it finished 100% it start the process again stated data corruption. I don't have backup/snapshot. Do I just lost the entire pool? (highlighted drives are the new drives I put in the pool)

Had a bad drive failed in a zpool with 12 x 2 TB mirror pool. Removed the failed drive with a new one and start the drive replace process. Looks like the zpool is in resilvering loop somehow. It went 100% on the resilver process then start process all over again and again. It has been 2 weeks...

The reference below could be a good fit for you.Complete vSphere with Tanzu homelab with just 32GB of memory!

try install windows first see if the drive show up

Try this VMware Knowledge Base

Thank you @gea ! I am running bare-metal for OmniOS and I do not have @StevenDTX 's issue. I am familiar with Solaris' RDMA requirement for IB which is why I moved away from Solaris based ZFS to Linux based ZFS (not as good) in the past two years due to lack of support for Ethernet support...

omniosce-r151034 support Mellanox ConnectX-4/5/6 out of the box

Is there possible to enable iSER on OmniOS? I was able to get standard iSCSI working with ESXi, but no luck with iSER. What's the best way to create an iSER target? (if needed) OmniOS Build - omniosce-r151034 NIC: Mellanox ConnectX-4 Napp-IT: 19.12 Client ESXi 7.0 NIC: Mellanox Connect 3 with...

very exciting news, is that means RDMA (iSER) finally comes to the stable platform for ZFS? :)

IB is not supported for vSphere 6.7. mellanox stop making IB drivers for vSphere. The Arista 7050QX switch a very popular switch at STH for 40Gbe.

Correct, that's the current requirement.

Good question, that's the current architecture.