Search results

Wow, I didn't realize they made SFP modules for GPON. (As in, I didn't know, and just did a search, and found at least a few...) That said, one thing I never knew was whether the ONT you get from AT&T does anything special, or if it's just a simple bridge. You have to redo 802.1x auth whenever...

Have been rather pleased with the 6610P-48P I got awhile back. Only thing I wonder: is there some way to unlock a MACSec license, short of buying one? Haven't seen any info around and it's about $800-$1000 (or more than 4x what I paid for my unit) for one. I don't need it, obviously; just want...

My understanding is that the counterfeits simply stop working too soon. I don't know about backdoors.

I wouldn't call it "dead-end" since many places have CAT5+ infrastructure and 10GBASE-T permits that stuff to be reused, so I expect it'll sell like hotcakes. And I imagine it'll continue to be installed long after SFP+ modules have been consigned to the scrap heap. That said, if you can do...

Use iperf3 and test the network alone, see what throughput you get.

If all you're doing is NAT, then any old computer from the last ten years (!) will do. I have a single core VM on a Xeon E3-1230v2 that handles 300 Mbps just fine. Utilization is fairly high (around 50%) but that's because the network card is cheap and doesn't do any kind of offload; if I were...

Depending on the modules you find, it can be pretty close. Cheapest I've gotten 1m direct attach cables for is about $16 each. As I mentioned, I found SR modules for $10, and 3m lengths of cheap fibre are about $4 shipped.

I imagine the rest of my network will remain gigabit while the VM host (doing fileserver, router, and other duties) gets an SFP+ port on the CRS226. So the CRS226 and VM host will just go in the closet and I'll use a SFP+ direct attach cable to go between them. The other SFP+ port... haven't...

I didn't have to do anything, so I don't know about that. :) Just plugged in a couple of gigabit devices and SFP+ modules, and switching seems to work just fine. I picked ConnectX-3 mostly because the $20 ConnectX-2 adapters weren't available then and because I'm trying to figure out how much...

FWIW, I have a CRS226 and have never done anything at all with the onboard configuration, and it just works as a switch. And it and my ConnectX-3 adapters happily use off-brand/never-heard-of-that-name-before SFP+ DAC and SR modules. Also, over small enough distances (see Wikipedia), older...

Thanks for the post; I just compared the I350-T4 I bought new from a 3rd party seller on Amazon and it looks exactly like the counterfeit one. Everything matches. It came in a sealed cardboard box that identified it as made in Malaysia and misspelled "adapter" as "adrpter" in one place. Newegg...