Find on Supermicro FAQ's
If Direct Mapping Mode were accidentally enabled on AOC-SAS2LP-H8iR and has caused the card to stop working, how can a user disable it?
Enabling Direct Mapping Mode allows the RAID controller assign drive numbers based how fan-out cables are attached to...
Hello! Have some problem with LSI MR 9361-8i raid controller.
For some reason MR 9361-8i can boot only on iMR firmware.
When I flash on controller MR firmware from LSI FW_16MB.rom or latest MR_4MB.rom it stuck on boot.
UART output with MR firmware only.
LSI Logic Boot loader V3.02.00.00-0001...
Don't know, buy it on ebay. No any labels except LSI. On this controller disabled raid 5 & 6 functionally.
I have another, but can't reflash it, when flash full firmware from LSI_Preboot then system can't initialise it. Short J6B2 jumper, boot into DOS and megarec3 see it, clean flash, reboot...
Esxi 7 free on X10SRH-CF LSA show integrated sas3008 and add-on sas3108.
Install lsi provider, enable sfcbd-watchdog, restart server. Connect to server with administrator account.
As I remember this procedure.
Glad that you success reanimate you controller.
Think that Megacli.exe from directory "boot\LSI\FW\Recover" is renamed Megarec3.
LSI PreBoot Installer for USB also have recovery ROM this is file "FW_16MB.rom" from directory "boot\LSI\FW\Recover".
You can try flash full 16MB firmware file from LSI PreBoot Installer. In this archive find megacli.exe and fw_16mb.rom in folder Recover.
Recover script from LSI in this PreBoot image with error.
So you can manually create bootable freedos usb disk and copy this file to it or do this with...
I am have server Supermicro X10SRH-CF board with integrated LSI 3008 IT mode controller and case CS-743TQ backplane SAS-743TQ rev 3.00. To backplane connect 6 sata disk, backplane connect to HBA adapter with cable LSI00411 (L5-00221-00).
Configure backplane for SGPIO mode (get config...