It looks like you are missing the gateway for your sub-interface? This is my working config on my M90q with Proxmox.
root@pve1:~# cat /etc/network/interfaces
iface lo inet loopback
iface eno2 inet manual
iface vmbr0 inet manual
Did you figure out what was keeping your 2x32GB sticks to work?
I just bought a M90q and ordered 2x32GB 3200mhz DDR4 SO-DIMMs (TEAMGROUP T-CREATE) from Amazon. Mine refuses to boot with both 32GB sticks in.
Either 32GB stick in DIMM1 by itself boots fine.
Either 32GB in DIMM1 + stock 8GB...
Tossed a E5-2678v3 in my home server and no longer need this processor. Processor has been running great for me for my home lab for many years now.
12c/24t 1.8 base 2.5 turbo
Intel® Xeon® Processor E5-2648L v3 (30M Cache, 1.80 GHz) Product Specifications
$65 shipped in the US...
USPS finally showed up this afternoon (Monday). Pop'd the card in my Win10 workstation and updated the FW. Shutdown my ESXi box and loaded ESXi 7 to a new thumbdrive. The ConnectX-3 is being detected right out of the box.
@nthu9280 I actually remember reading a little bit on those threads about those boxes. Cool idea. The only thing I might get stuck with is the built in realtek NIC for the WAN side of pfsense, unless I threw a 2-4 port copper card in the PCIe slot and didn't worry about uplinking back via...
What is everyone using for dedicated firewall solution these days? I was previously using a Zotac CI323 running ESXi with a pfSense VM on it until lightening from the tropical storm took out both my cable modem and the interface I was using for my WAN port in one shot.
While I liked the ESXi...
You most definitely should be able to setup a L2 only (non-routed) vMotion VLAN between your two hosts located on different switches. Running them L3 to your Sophos box just complicates things further, and depending on your uplinks/switch speed, could slow things down.
I bought a Windows 10 Pro key for my new Asrock Deskmini PC and it was delivered within minutes. I went into a fresh Win 10 Pro install and hit change key with the key provided and it activated without issue.
GENUINE WINDOWS 10 PRO 32 / 64BIT OEM ORIGINAL LICENSE KEY- SCRAP PC | eBay
How is the provider handing off the circuit to you? Are they providing you with your own CPE equipment? Since 2G speed is not super wide spread, I would assume they will giving you some type of router/FW to terminate the circuit into?
Sat Mar 25 07:07:49 2017 Warning: address 192.168.1.1 is not a network address in relation to netmask 255.255.252.0
Your mask (/22) does not match the given network (192.168.1.1). Given that netmask, your network would be 192.168.0.0/22 with a range of 192.168.0.0-192.168.3.254. I assume a...
Juniper will throw an alarm if the out of band management interface is not cabled.
root> show chassis alarms
1 alarms currently active
Alarm time Class Description
2016-01-20 07:17:13 UTC Major Management Ethernet Link Down
Can you screenshot us your routing table from the ex3300 (show route) and also on the PFsense box?
I don't understand from PFSense why it cannot ping 30.2, because that is a directly connected network.
They need to add the static routes on the PFSense box because their 172 networks are not directly connected, and thus not in the routing table on the PFSense box. If his VLANs/subnets were all interfaces/subinterfaces directly off the PFSense box (Router on a Stick), then they wouldn't need any...
NEW 64GB SATADOM 3ME SATA 6Gb/s 280 MB/s Read MLC DESSL-64GD07RCADC | eBay
This seems like a good deal if you are looking for a moderate sized SATADOM. I am hoping I could use one to replace my single SSD I use as my local datastore that boots my Napp-it VM?