I knew the reason I couldn't assign 10.0.0.3 was because it's part of that broadcast address. Is there anyway I can change that so I can use 10.0.0.1 for the router, 10.0.0.2 for the switch and 10.0.0.3 for the access point?
So I need to assign an adress to the R710 that is the same subnet as...
I've had a Brocade ICX-6610 for a couple years now and just recently bought a Ruckus R710. I'm running VyOS and am having issues assigning an IP to the R710 that is in the correct VLAN.
Startup-config data location is flash memory
I tried that and still had issues, I realized I could actually ping out to google from one of the systems I was having trouble with so I went into pfSense DNS Resolver and added that vlan subnet to the access list and everything seems to be working. I'm not sure if this is the correct fix, but...
I'm having issues getting internet access to my VLANs. I have a PFSense router and a Brocade ICX6610. The VLANs can all see each other, and the switch can ping out to google, but I can't get anything on any VLAN to see outside of my LAN.
My PFSense router is 10.0.0.1 and I've added a gateway of...
Cable: 2x Mini SAS to Mini SAS (SFF-8087)
1x Mini SAS to SATA Breakout (SFF-8087)
Cable: 3x Mini SAS to Mini SAS (SFF-8087)
Would this be the correct cables needed for each?
I'm completely lost, what raid controller and cables would I need for the following two systems?
10x 2.5" Trays
12x 3.5" Trays
I'm just looking to run Proxmox on both of these and have the drives in...