7150 has no fan. It feels warm outside not hot. I recently replaced the broken 7150 power supply with a MeanWell one and a fan because the MeanWell power supply provides fan power.
I have another broken 7150 which constantly prints
" "PoE Fatal: Vmain (48V) fault has forced all ports on...
The cert and keys are stored in a ubifs volume mounted as /opt
mount -t ubifs -o sync ubi1:resources /opt
I got this from a bad update:
Resources partition is...
He rejected my offer at $40 and jacked up list price. Here's a supplier from HK LB130S56K | Ault / SL Power LB130S56K Stock available from Infinite-Electronic.hk | LB130S56K with Best Price at Infinite-Electronic.hk .
After a failed flash attempt on icx7150, the next boot says the flash is to be reformated and device keys deleted. The following command fails:
SSH@ICX7150-C12 Router(config)#dm verify-device-certs
Commencing sanity check for device certs ...
Verifying TPM files ...
Failed: Check TCSD_PS...
I have been using this board with six HGST 10T drives for about five months. After a recent addition of Intel Optane 16G M.2 drive to the board, I am getting SATA reset on all the drives. Removal of the Intel M.2 does not change anything.
ata15: link is slow to respond, please be patient...
I got two Brocade XBR-000232 QSFP 57-1000267-01 4*16Gb. When I plug them to 6610 breakout ports, show media displays it as 40GBASE-Passive Copper with or without fiber. I am using this Plenum MTP MPO to 4LC Fiber Optic Breakout Cable, OM3 50um, 3 Meter | eBay . This has a male connector. I...
Anybody uses QPF+ to SPF+ convertor on the LB6M?
I cannot ping Mellanox Connectx-3 VPI HCA through the convertor.
But direct connection of two SPF+ ports via DAC works.
The MAC address of the Mellanox port is displayed with
show mac-addr-table on the switch. I have no idea why I cannot ping it.
I have trouble updating the firmware.
All nvmupdate versions from intel say update is no available.
ethtool -i ens4f1
firmware-version: 4.10 0x800011c5 0.0.0
Anybody knows how to enable management port two? telnet to port 2323 and log in as root; I see eth0 and eth1. eth0 is management port one.
I give eth1 an ip but can only connect to it from management port one jack.