When I followed the guide, I would get the following error:
Updating BOOT image over TFTP
Using FM1@DTSEC1 device
TFTP from server 192.168.1.2; our IP address is 192.168.2.2; sending through gateway 192.168.2.1
Load address: 0x1000000...
I ran the u boot update again and reset the switch. The version is now 10.1.18. I ran into the same issue for the primary update where I'd get the "Primary image download failed". I think this had to do with my tftp server timing out. Rather than spending hours trying to diagnose, I just used...
Just received a new (to me) 7250-24p. Walking through the setup guide, the uboot image updates just fine, but the primary image fails.
All I get is:
Loading image to Uboot Partition 1
Using bcmiproc_eth-0 device
TFTP from server 10.22.102.17; our IP address is...