Were you placing them next to one another? That’s a huge no-no
I have a bunch of these and I have no problems getting full 10Gb. My biggest complaint is that my revision 1 don’t support jumbo frames.
The Unifi might not have enough cooling in the right place to run these. They definitely...
I definitely hear you there. I’ve been tearing through switches in the last year and have seen much of the good/bad/ugly/etc.
Cisco pretty much simplifies it down on a per interface basis to:
Choose native vlan
Choose tagged VLANs to allow/deny
Choose trunk vs access
The fs.com switches are...
This is a bit of an informational piece for anybody that owns a SA120 for a DAS.
In case you don’t know, if you have dual PSUs, the fans on the DAS auto adjust to reasonable levels. I’m someone that picked up a lot of these when they were sub $200.
I’ve been looking for reasonably priced...
Just with the way the rest of the VLANs work, it’s clunky and disconnected. I ran into some goofy circular issues trying to change the native VLAN on a port to like 9, then tag in some other ones.
It’s just weird to have all your VLANs: you tag your trunk ports, untag your access ports, but...
So I’ve finally navigated the Brocade desert and have found the promised land.
6450-48p was the first switch that I ordered. It worked perfectly but I suffered from a bit of a layer 8 issue here. I didn’t do my homework and discovered this switch doesn’t support dynamic IPv6
6650. I ordered...
Seems my brocade adventure just won't end.
Got a 6610 today. Model number is ICX-6610-24-PE, Version:07.3.02T7f5
Before I did anything else loaded it up. And there is absolutely no signs of this switch supporting PoE. Every other switch mentions initializing PoE on booting.
Yep. It had a burnt out board. Seller had me run 'no inline power' and 'inline power', and the "has NOT changed." didn't pop up. What it did cause was the USB->Ethernet that I had plugged into my NUC for initial config to literally start smoking and start on fire.
So second 7250 arrived from a different seller... and I think it’s a dud again.
Anybody know if this is expected?
PS 1, Internal Power supply detected.
PS 1, Internal Power supply is up.
PoE: Stack unit 1 PS 1, Internal Power supply with 370000 mwatts capacity is up
PoE Info: Adding new 54V...
That's what has me a bit concerned. Even after it finishes booting and quiets down, the lights stay on:
Problem 2 is that none of the link lights come up, except for the management port, when plugged into another switch. The link lights DO turn on on the opposite switch, except for the...
Finally got the 7250. I'm not sure if I got a broken one or not.
Is it normal for three of the ports on one side of the switch to be lit up solid green full time? From boot to when the fans cool down?
No matter what I've tried, I've been unable to get anything out of the serial port. I...
Are you loading it up with spinners or SSDs?
You really can't saturate even 6Gb gear with 10 drives if they are spinners. If they are SSDs, that's another story.
I mean for "really cheap", the HPs can't really be beat. Ironically enough, half the ones on eBay for half that price that say...
Right, but on ESXi, there are two places you need it.
On the vSwitch/dvSwitch
On the VMKernel adaptor
So check to make sure your vmk0/1 whichever is attached to that portgroup/dvSwitch is marked a 9000 MTU.