(For background, see here:
I got refunded for my purchase and seller doesn't want them back, so if someone wants them for shipping, I'd rather than than toss them out. My icx6450 can talk to all 4 transceivers, but I...
Ok, bought 2 5m SFP+ DACS off of ebay, described as 5m passive DAC cables.
They are labled as SFP-H10GB-ACU10M
I plug them into an ICX6450, it detects them as follows:
Port 1/2/3: Type : 10GE Active Twinax 10m (SFP +)
Vendor: CISCO-TYCO Version: A
Thank you! That totally eluded me.
Yes, I'm aware I will create a loop, but I was thinking I'd get a link at least. I don't get a link....I do have a powered down Aruba S2500, but would need to reset it to avoid IP conflicts...
(Is there no way to search in a specific thread? I could not find!)
Question: I'm trying to use a couple cisco DAC cables. When I plug a cable in to my 6450, even if i plug it into two ports, i get a message "optics inserted, wait for PHY initialization", and nothing else happens.
Can you use LSI Storage Admin or MSM to display the drive link speed, capable speed, and negotiated speed? I know with LSI SA I can go to the controller, more actions, configure link speed and set it for each device; plus click on the "..." next to each device and show the supported and...
I'm running an older verion of Minio on a pi, 2017-08-05T00:00:53Z, with duplicati.
duplicati settings I use:
Amazon S3 storage
custom server url
bucket name is backups, but was created by duplicati I think
bucket region is default
storage class is default
client library is amazon aws sdk...
Is it possible to rate-limit traffic on a specific vlan?
IE I'm running all VLANs trunked to firewall currently on e 1/1/1. I'd like to limit one of those vlans to say 15MB/s, to preserve bandwidth for other uses. Is that possible?
ICX6450-48p power draw;
Just as a data point, under low load, the UPS which runs my switch/usg/cable modem is showing a typical load of 73w with 17w of PoE devices. I suspect that there is a minimum value the P/S and electronics will draw regardless of PoE load. This is really no different...
It may have been related to an optic, hasn't shown since I removed one I wasn't using.
dm i2c diag shows:
stack: 008779b4 0171327c 016e9b34 0123f218 0123f68c 00454a94 00459238 00455c8c 00459ab0 00455c8c 00459ab0 0044f510 00879f54 002c0438 00a2342c 019d86e0 019d93f0 00a23dec 016d9d0c 0228f2ac...
Just got a 6450-48p to replace my aruba s2500-24p, and have it all up and running now. I noticed in the console log a few messages like this:
Error: I2C access failed for device 0x50, command -1071879421, I2C code = 0x1, SIM Code = 14, TWSI Sts = 0xf8
Anyone know what that means?
The GZ and GL are the same, except for 16 or 24 dimm slots.
The CX-2 will be enforced at pci 2;
for the pci 3 list.
I was able to get a pair of 2650v2 for $75 or so shipped last year, that was...