I bought one of these on ebay and I could not enable the web interface so I configured it using the CLI.
I would like to enable the web interface but I cannot seems to get it to work, I have tried using both the service port and the inband network.
One think to note the javamode command in the CLI doesn't have an option to enable it.
network protocol none
network parms 10.10.20.157 255.255.255.0 10.10.20.1
network mgmt_vlan 1
if I do a network ? I see
(48switch) #network ?
javamode Enable/Disable.
mac-address Configure MAC Address.
mac-type Select the locally administered or burnedin MAC
address.
mgmt_vlan Configure the Management VLAN ID of the switch.
parms Configure Network Parameters of the device.
protocol Select DHCP, BootP, or None as the network config
protocol.
(48switch) #network
but when I do network javamode ?
(48switch) #network javamode ?
<cr> Press enter to execute the command.
(48switch) #network javamode
When I try to access the web console I get connection refused
any ideas?
I would like to enable the web interface but I cannot seems to get it to work, I have tried using both the service port and the inband network.
One think to note the javamode command in the CLI doesn't have an option to enable it.
network protocol none
network parms 10.10.20.157 255.255.255.0 10.10.20.1
network mgmt_vlan 1
if I do a network ? I see
(48switch) #network ?
javamode Enable/Disable.
mac-address Configure MAC Address.
mac-type Select the locally administered or burnedin MAC
address.
mgmt_vlan Configure the Management VLAN ID of the switch.
parms Configure Network Parameters of the device.
protocol Select DHCP, BootP, or None as the network config
protocol.
(48switch) #network
but when I do network javamode ?
(48switch) #network javamode ?
<cr> Press enter to execute the command.
(48switch) #network javamode
When I try to access the web console I get connection refused
any ideas?