32GB DDR4-2666 RDIMMs $85 ea

Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.

cookiesowns

Active Member
Feb 12, 2016
234
83
28
28
Given the rank requirements of EPYC. I bet they’ll only work in 1DPC scenarios without heavy downclocking.

Hell running 2DPC on cascadelake with the 2933 bumps them down to 2666
 

timd

Member
Dec 12, 2016
53
24
18
51
I previously ordered several terabytes of memory from these guys about 5-6 years ago. Used it in Poweredge M910 and M610 blade servers. They are a smaller manufacturer up in the bay area, I think around San Jose. I still have pieces floating around from servers long gone that seem to hold up. I did have some bad pieces but also had some self generated issues at the time as I did not understand rankings, chipset limitations and problems inherent with mixing different ones. They did always stand behind their warranty. This looks like a killer deal, thanks for posting! Definitely going to pick up some.
 

cookiesowns

Active Member
Feb 12, 2016
234
83
28
28
How is the performance and reliability compared to the branded Micron, Samsung etc?
performance is going to be negligible In difference if any. Reliability.. well that’s a tough one. I can say the PCBs seem to be of a “cheaper” quality.
 

cookiesowns

Active Member
Feb 12, 2016
234
83
28
28
They don’t appear to, or at least my EPYC on an h11ssl-nc wouldn’t post with them.
Interesting. What BIOS?

I have a Dell R6415 with a 7251. Running 1 stick of the 3DS 2933 at 2400Mhz now.. will try populating 8 dimms shortly.

Decided to put 8 dimms into the other system with the 7351P. These are with the 3DS 2933 dimms. the 2666 dimms are in an operating system right now..

Looks good! I'm doubtful 16 dimms will work... but 256GB of ram for $680 is not bad at all.

 
Last edited:

denywinarto

Active Member
Aug 11, 2016
238
29
28
40
Any idea if these'll work on z390? I have 2 Z390 board, one is supermicro and the other is gigabyte
 

Jon

Member
Feb 28, 2016
77
18
8
42
Also pretty sure these will not run on z390.

As for my xeonD-15xx question before it looking like a no also

Progress?

Using other ram in supermicro to change thing in bios bio then going back to this stick.

With POR enable get config not supported with it desable I get a memory signal is to marginal and will not continue.
 
Last edited: