I have an ICX7250-24P and ran through the updates and I think something is wrong with PoE on it. whenever I try to install the PoE firmware I get this message:
and on reboot I get these messages:
has anyone seen this before or do I just have a bad switch? show inline power says "internal h/w fault" after installing the firmware, but that message goes away after a reboot. PoE still isn't working though on a factory reset default configuration
Just tried every port and PoE does work on 17-23 (but shows as "Non-PD") so I guess it's probably a bad switch
Code:
PoE Info: FW Download on slot 1...programming firmware...completed.
PoE Info: FW Download on slot 1...upgrading firmware...completed. Module will be reset.
PoE Info: Resetting in slot 1....
PoE Info: Resetting module in slot 1....completed.
PoE Error: Failed Devices Bitmap on PoE module:4, numDev:3.
PoE Severe Error: Hardware Fault with ports 1/1/17 to 1/1/24. Remove PDs and then configure "no inline power" on these ports.
PoE Info: PoE module 1 of Unit 1 initialization is done.
Code:
PoE: Stack unit 1 PS 1, Internal Power supply with 370000 mwatts capacity is up
PoE Info: Adding new 54V capacity of 370000 mW, total capacity is 370000, total free capacity is 370000
PoE Info: PoE module 1 of Unit 1 on ports 1/1/1 to 1/1/24 detected. Initializing....
2000 log entries of PoE Event Trace Log Buffer is allocated on unit 1 for unit 1
PoE Event Trace Logging enabled for unit 1
PoE Error: Failed Devices Bitmap on PoE module:4, numDev:3.
Resetting module in slot 1 again to recover from dev fault
PoE Info: Hard Resetting in slot 1....
sh: can't create /proc/iproc-i2c/iproc-i2c0/iproc-i2c-reset: nonexistent directory
PoE Info: Resetting module in slot 1....completed.
pdsineReadResetResponse: Received an all-0 message
PoE Info: Expected post-reset system status response not received from the controller in slot 1...so reset of i2c will be initiated first to recover.
PoE Info: I2c Reset in slot 1....completed.
PoE Info: Hard Resetting in slot 1....
PoE Info: Resetting module in slot 1....completed.
pdsineReadResetResponse: Received an all-0 message
PoE Severe Error: Controller Reset failed on unit 1 in slot 1
Just tried every port and PoE does work on 17-23 (but shows as "Non-PD") so I guess it's probably a bad switch
Last edited: