SM-CSE-743TQ

Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.

thorin

Member
Aug 30, 2016
35
0
6
124
Anyone got this chassis and want to verify/confirm if any other than the X9 cards listed on the support page will fit?

Supermicro Products | Chassis | 4U | SC743TQ-1200B

C7Z87-OCE X10DAC
X10DAi X10DAX
X10DRH-C X10DRH-CLN4
X10DRH-CT X10DRH-I
X10DRH-iT X10DRi
X10DRi-T X10SAE
X9DA7 X9DAE
X9DAi

Actually there's a possibility I could grab a Asrock EP2C602-4L/D16, would this fit?

As I can't figure this out as the dimensions for the rest of the X9D* also would fit... and this limits my X9D* cards for the 2670 setup :/

Also, if you know if the 1200-B vs 1200-SQ only difference is the fans in regards to being labelled SQ - I'd like to hear a POV on that too. Actually while we're at it, how loud/quiet is this?
 
Last edited:

thorin

Member
Aug 30, 2016
35
0
6
124
Last edited:

i386

Well-Known Member
Mar 18, 2016
4,220
1,540
113
34
Germany
Anyone got this chassis and want to verify/confirm if any other than the X9 cards listed on the support page will fit?
The Supermicro site says that this chassis supports EATX mainboards and the EP2C602-4L/D16 is an EATX mainboard.
You might need a power supply extension cable for the cpu socket near the io shield.

Also, if you know if the 1200-B vs 1200-SQ only difference is the fans in regards to being labelled SQ - I'd like to hear a POV on that too. Actually while we're at it, how loud/quiet is this?
The SQ version has less and slower fans than the B version and is using different fan holders.
I don't have this chassis and can't say anything about the noise levels, but if you're not using server mainboards from Supermicro the fans might run at full speed all the time (SQ fans 25 db, B fans 45 db).
 

briandm81

Active Member
Aug 31, 2014
300
68
28
42
The Asrock EP2C602-4L/D16 is actually not an E-ATX board. It is SSI EEB. They are similar in size but have a different arrangement of holes. I have one mounted in an 846 and I was able to find all of the hole that matched up.