Recent content by synchrocats

  1. S

    500GB SAS SSD is only 200GB

    Any luck with resizing?
  2. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    Also, does anybody got a working pci bifurcation? I saw it in manual and in bios firmware (with other interesting features like TDP control via AMIBCP 5.02), but I can't see it in bios
  3. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    Just to note: If you somewhere in the night stuck with f*cked up bios and cannot recover it with IPMI use Supermicro Update Tool: /SUM -i 192.168.0.107 -u ADMIN -p ADMIN -c UpdateBios --file <PATH TO BIOS FILE> --force_update --reboot Also, bios chip for x10qbi is mx25l12835fmi-10g
  4. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    Does anybody tested config with mixed CPUs? like 8890v3 and 8891v3? does the core count should be the same?
  5. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    Now I have v2 CPUs, and I think I will try turbo lock hack when I will go to v3
  6. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    Hi everyone, maybe you know what PLL (clock generator chip) is used on X10Qbi? It could be fun to overclock FSB slightly by modifying PLL chip registers.
  7. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    I played with midplane fans PWM when there was standard heatsinks - When I got watercooling, midplane was removed completely
  8. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    From my expirience system doesn't start with one CPU. Two CPU config doesn't tested by me, and 3x CPU started with 3x memboards with 4x DIMMs installed in each MEM board. For the unkwown reason when I installed 6x memboards rear fans stopped and newer turned on again, so I removed It. Midplane...
  9. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    So, it's a long story:) As I know, there is no cheap LGA 2011 narrow AIO water coolers. I bought four Gammaxx L240T and designed custom mounting brackets that was laser cut from 2 mm AISI304 steel. Also, standard mounts (6mm) was too high, and I used set of DIN912 M4x20 bolt + one stanard nut +...
  10. S

    X10QBI and v3/v4 cpus (e.g. supermicro sys-4048b-trft)

    hi, I'm making quilet workstation with watercooled x10qbi, I can post some info about how it's going if anyone interested