Ahh i got it! Thanks!
I needed to add --six
And it worked space went from 822gb to 838gb after going from 528 to 512. A lot of wasted space.
Thanks for your reply!
I tried and was successful in using the psid. I can format it to current format but I can't change sector size. I get the same error.
I can size 528 all day but 512 errors.
Am I missing something?
Any help appreciated
I did the same thing Bjorn Smith did and ran 6x flx noctua. 4x in fan chassis and 1 in each power supply. Slight hum but I can sleep in peace with it on. Full speed 100% of the time.
I don't run fully loaded and never will and doubt noctua fans will hold at fully loaded. I have 7 ports active...
I have the CCR2004 and my unit is 100% Silent even when decently loaded with few 10g rest 1g and 3 open sfp+ ports.
can't say the same for my brocade ICX6610-24 :eek::eek::eek:
I was going to grab the CRS326-24S+2Q+RM but cost savings won. I heard the CRS326-24S+2Q+RM is silent or near...
ordered new cables and new card and that did the trick.
thank you! now I have 1g, 10g, 25g, and 40g capable home network :-)
also have a DAC breakout cable on route to connect to my ccr2004-1g-12s+2xs since the front sfp+ ports are trapped in 1g hell.
I actually did not do that and somehow missed that.
I did finish doing it wrote to memory and reloaded switch to same issue
yes I'm sure I'm not plugged into the breakout ports. heck I even had all 4 ports connected (curiousity) and nothing.
I have 1 to the is5030 and other to sx6025.
I'm...
hello,
I'm test driving the brocade ICX6610. I was looking at the Mikrotik CRS326+24s+2qm+rm but stumbled upon this thread and work happen to have 1 left so I decided to take a peak at it before deciding to buy it. figure I'd save a few coins If I can get this working.
took few cables but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.