Hi, I need help with firmware for HUSMR7638BHP3Y1.
I have 2 of them branded HGST, one is used for a long time and need to be replaced. I made a mistake while updating firmware. There was 5 firmware slot as below;
frs1 : 0x313630504e47544b (KTGNP061)
frs2 : 0x313730504e474e4b (KNGNP071)
frs3...
I think I found the problem, but have no idea how to solve. There is small warning when I boot the switch with 8030u;
ICX7250-48 Switch>Successfuly set IngressClassPort on CPU port to 2
PS 1, Internal Power supply detected with no power.
ICX7250-48 Switch>en
Is there any idea what causes...
one of the fans was not spinning before upgrade, I cleaned it with sprey. After cleaning it started spinning, then I booted the switch and upgraded. Also checked the fan, speed is normal. It was FAN1. I’ll try replacing the fan.
Hi all, I need a small help. I have Brocade ICX 7250-48 without POE (non-POE) . Basically single PSU without FAN. Running 8030u firmware. But when I upgrade 8080 or 8070 I got error at boot;
FATAL ERROR: At least one good PSU with working Fan should be present in the system
System is shutting...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.