Hey guys,
I'm helping out a friend of mine and needed some information. He has a HP Proliant 380p Gen8 server that he's gotten the HP p410i card for. The card has a backup battey that has a long cable but no place to mount the battery. Can someone tell me where we should place the battery? We...
Make sure the power supplie is in the top (PSU1) PDB. I had the same issue and it was because they shipped plugged into the bottom PDU. It kept giving me the error that the PSU1 had a fault and needs to be replaced.
I was looking into something like that for myself. I'm thinking of putting my server in the attic but with Texas heat its impossible without an AC unit. Was looking to get a cheap portable AC unit and making an insulated rack to house the server in. I'll have to figure out what to do with it...
I just ordered a pair of Samsung 840 pros and was wondering what adapter you guys are using to make it work with the 3.5" hard drive trays?
Any help would be much appreciated.
It didn't do it on my older PIC16 (5pin) enclosure but it does spin up on the new PIC18 (7pin) enclosure. The FCB firmware are not compatible with the PIC16 (5pin) boards.
Server Manager > Tools > Hyper-V Manager
On the left side you will see Hyper-V Manager and your server name listed under it. Click on the server name and on the right hand side you will click on New > Virtual Machine.
Hope that helps
Adam,
This is what i've been able to come up with. I was unable to find the cables on ebay but maybe you can message the ebay seller to see if they can find it. The pages i refer to are from the Hardware Owner's Manual.
Difference between the PIC16 and PIC18 enclosure:
Fan Control Board -...
Adam,
I ended up talking to my ebay seller and he sent me a new enclosure with the PIC18 board and corresponding PDU boards/cables. Let me look at the difference between the two enclosure and document the changes for you. It'll take me a little time so please bear with me.
My problem was that it wouldn't ever slow the fans down. It would start at a high speed and stay there. Very loud. :| I tried all the different power management settings to no avail. Another problem was that it was not displaying anything for fan rpm under the server health section of IPMI. I...
So I wanted to give some information to everyone. I've been trying to change the FCB from PIC16 to PIC18 cause of an issue i am having with the PIC16 board. There are a few different connectors between the board. It seems you will have to change the power distribution board (both of them) in...
Thank you so much for that info. It's been really helpful. I'm gonna see if I can trade my 5 pin fans for the 7 pin fans but I myself have been thinking of changing the fans for the San Ace fans. I just bought the 6 pin connectors (since it'll take them forever to arrive) and will be buying the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.