On my ICX6610, I noticed the license capacity is 8 for ICX6610-10G-LIC-POD. Does this mean I can only use a maximum of 8 10g ports between the front and breaking out the 2xQSFP+ ports on the back? Is there a separate license needed to use both the QSFP+ break outs and the 8 SFP ports on the front?
Concerning the 40G to 10G breakout setup on the ICX6610, I can’t seem to get the 40g to 10g breakout working. I have:
a 40G-QSFP-SR-INT optic (also have the infiniband optic mentioned in an earlier post)
fiber: female MPO to 8x LC OM4
10 G brocade optics and intel optics
I have connected...
I was able to snag a Rev C PSU & a PSU blank from ebay. Unfortunately, when I boot the switch with only that PSU, it says:
Fatal Error: PSU fan is not present or FAN has failed
I tried swapping the PSU into a different slot, and mixing the Rev C & Rev A PSUs, but every time it shows the above...
I know this was posted awhile ago, but it's possible to get an R720 to run in 65W. To do so: slim down the server to 64gig, 1 CPU, and then use the internal header for a hard drive (instead of the bays). This is what I did to convert one to a local router with a Xeon V2670, a daughter board...
Popping in to say I'm joining the ICX6610 club as well. Received the switch yesterday and it's been a wonderful device.
My only question is: does anyone have a suggestion where to get a blank for the back power supply slot? I wanted to run the device with a single PSU instead of dual.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.