Thank you again!Read through the post you mentioned and this post and then found out that I need B4 with +5V to start the MB. And it worked!
Now need to get a CPU fan!
I tried an HP 750w server PSU and now can successfully deliver +12V and ground. However after I soldered the PSU's +12V and ground blades with motherboard's power connector male heads, the motherboard(I only have one node, no midplane no 2-node chassis) couldn't boot up. I measured the voltages...
Thank you for your guide! Since the original post was deleted, I have to double confirm. "And large planes on left were used as positive and negative connections." - by saying this, you actually meant PSU+12V should be soldered with P1 and P2; PSU Ground should be soldered with P3 and P4. Is...
How to connect the PSU+breakout board+8 pin EPS cable (I already have those) to the midplane board or the motherboards? All the previous posts showing the wiring have been deleted. Appreciate if you could give some instructions. Thanks!
Or just 2 of the same type of CPU?
When I shopped on ebay for a dual LGA2011 motherboard to host dual CPU, I saw something like it "requires a matched pair" of, say, E5 2680 v2 CPU. "Matched pair" means they have to be from the same batch of production of the same model, or just any 2 of the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.