well... finally got it boot (brought back to service) .... they did some manipulation with "jumpres" on the board with the same DIMMs.
But now I have problems with BMC :( (card is installed at MB connect + green link is on when WB is on)
Looks that manual has nothing about it.
with outside case -> didn't manage... MB Supports ATX2.0 PSU ... I have as an second PSU only ATX (with 1 connector) :( ... and it doesn't work with ATX (not 2.0)
I have also DDR4 ECC Registered DIMM (DDR4 | Synology Inc.) for test from Synology,
but I think it won't work because E-2300 doesn't support Reg.DIMM :(
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.