This is what I get now. I think I configured it correctly.
Not much improvement with sequential, but significant improvement from random.
I'm not used to what is considered good speed for random because I'm coming from the consumer world where sequential is touted.
Hello,
I purchased four Samsung 983 DCT m.2 NVMe drives and their performance leaves much to be desired. While Samsung says that they should reach 3000MB/s read and 1400MB/s write, I don't reach those speeds.
I'm mostly concerned with read speed as these are meant to be holding my VHDs on...
I seem to have not been able to find a list of Intel chipsets that support SSD TRIM so hopefully you guys can help.
I have a Supermicro X9DR3-F motherboard, and it has an onboard C606 chipset. When I built this server, I couldn't find anything definitive, so I ended up using a Dell H330 HBA to...
So, the issue is that I have an Unraid server, and I wanted NVMe cache in a RAID 1 mirror. I don't believe that would be a good idea on those Intel cards.
That's the thing, I don't want anything complex, but no matter what I do here it doesn't seem as though I'm understanding.
All I want is 5 VLANS similar to the guide here: pfSense baseline guide with VPN, Guest and VLAN support
But this is to too much for me to do via CLI without some kind of...
Thanks. Does anyone have a guide on how to get these working with pfSense. I don't think I'm capable of translating some of the guides you see around for Netgear and Cisco switches into Brocade. If I can't get this working I'm going to have to return this or resell it.
So, I'm looking to quiet down the 1 fan that this ICX 6450-24 has in it. I did a little searching in this thread and I've seen the NF-A4x20 FLX and the Sunon MB40201VX-000U-G99 has been used by a couple folks, but it looks like these fans will cause a boot loop until the stock fan is put back...
So, I think a lot of my frustration was learning CLI. I also did a dumb thing and didn't consider that since the switch's DHCP server was off that I had to use a static IP on the client to get to the webUI. Then, once I registered the switch with the router's DHCP I was able to give the switch...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.