I'm talking about the BB deal case. and yeah my clips are on the back side as well.
I dont have my case near by so i am improvising on the image.
The red area on the pic both top and bottom is where i started with the flat head screwdriver, i get a little started then put the flat automotive pry tool in and leave it there, then i start the other side using the same process. Once both are in there just gently push on pry tool to wide the size of the gap, do i on both sides evenly then the tabs in the back will unclip "pop" out, then its just sliding the unit out in the direction of the blue arrows.
Again that is what worked for me, and i got two perfect cases that way. I didnt try it with a card the first time so that is why i didnt try going in from the back side where the usb is with these sets.
I dont have my case near by so i am improvising on the image.
The red area on the pic both top and bottom is where i started with the flat head screwdriver, i get a little started then put the flat automotive pry tool in and leave it there, then i start the other side using the same process. Once both are in there just gently push on pry tool to wide the size of the gap, do i on both sides evenly then the tabs in the back will unclip "pop" out, then its just sliding the unit out in the direction of the blue arrows.
Again that is what worked for me, and i got two perfect cases that way. I didnt try it with a card the first time so that is why i didnt try going in from the back side where the usb is with these sets.